Josh93 1 Posted December 24, 2020 Hello all im looking for a 2.8 inlet manifold if anyone has one for sale Regards Josh Quote Share this post Link to post Share on other sites
sheffieldcortinacentre 274 Posted December 24, 2020 (edited) Presume you have inj? 2.3 will also fit. If complete I'd stick with the inj you only need to mod tank for pump done loads. Edited December 24, 2020 by sheffieldcortinacentre Quote Share this post Link to post Share on other sites
Josh93 1 Posted December 24, 2020 not a fan of injection and have already brought the carb i have two manifolds here which would be best to use Quote Share this post Link to post Share on other sites
phorbiuz 36 Posted December 24, 2020 I have both a 2.3 and a 2.8 inlet manifold for my eventual build too. They look identical but they're stamped different so there must be an internal difference in my mind, otherwise why would Ford go to the extra hassle and cost of having different markings. For a 2.8 I'd stick with the 2.8 inlet manifold. Getting a decent 38 dgas with all the fiddly bits has proved the hard part for me. Quote Share this post Link to post Share on other sites
Josh93 1 Posted December 24, 2020 Im unable to source a 2.8 one atm just has two 2.3 ones , I need loads of bits too unable to find anything a year ago there was loads of bits about but I’ve heard a lot of people are doing the same Quote Share this post Link to post Share on other sites
sheffieldcortinacentre 274 Posted December 24, 2020 Inn is slot better all-round, wish I could get a full setup for my 302 Quote Share this post Link to post Share on other sites
